Grinding Point For American Scythes
Product Description
An affordable alternative to wet grinders for grinding the hard steel of American scythe blades, these grinding points are formulated specifically for use on thin sections of hardened, heat-sensitive steel. Just chuck it up in an electric drill or die grinder and grind at 7-9° per side (just above flat) to put a keen, crisp bevel back on your battered old blades.
Beveling only needs to be performed about 1-3 times per season, barring damage from impacts, and is done in just a few minutes when using one of these points. When a whetstone is no longer enough to get the blade effortlessly sweeping grass from the earth, give it a quick re-beveling to get the edge thinned out again. Made in the USA!
Do not exceed 16,100 rpm with 1/2" overhang. Wear eye protection.
Beveling only needs to be performed about 1-3 times per season, barring damage from impacts, and is done in just a few minutes when using one of these points. When a whetstone is no longer enough to get the blade effortlessly sweeping grass from the earth, give it a quick re-beveling to get the edge thinned out again. Made in the USA!
Do not exceed 16,100 rpm with 1/2" overhang. Wear eye protection.